Pro Convert device supports control of the network camera via the Visca UDP protocol, without the need to use a PTZ control line to connect the Pro Convert device to the PTZ camera. Steps are as follows:

1. Log in to the Pro Convert Web UI.
2. In the PTZ tab page, set the following parameters:
   • Protocol: Visca UDP
   • IP Address: The IP address of your camera
   • Port: Your camera's Visca protocol network port (check the user manual of the camera or contact the manufacturer to get it)
   • Visca UDP message header: Turn this option on if the transport protocol your camera (e.g. SONY camera) uses the Visca UDP header.
3. Click apply to make the above configurations take effect.